Fireball Digital Measuring Probes or Digital Gaging Probes
Fireball LD: Available with
metric or English/Inch engineering unit ouput (see panel on right) or with original connectivity to Albion's DigiGage software.
Download Fireball datasheet - click here
Download Fireball driver
here
(Required for use of Fireball LDs
that output ASCII engineering units, i.e. mm or
inch)
Connects directly to computer
USB port or via USB hub.
The lowest cost, easiest to use digital gage probe available. Plug one or more Fireballs into PC USB ports and connect to your gaging software, or install our gaging software and you have an instant gaging system. Our gaging software can output to other software, such as an SPC or preferred gaging program, on your PC or on another PC.
Digital gaging probes available with the following measuring ranges:
2mm
4mm
8mm
-
Low cost, user friendly digital gaging probe or digital gage probe.
-
Cost per measurement channel lower even than LVDT with signal conditioning board or other gaging probe.
-
Instant USB connectivity of electronic gaging probes.
-
0.0001 mm/0.000005 inch accuracy and repeatability.
-
1mm (0.04 inch) measurement range, linear throughout.
-
No expensive external signal conditioning and amplification circuitry required.
-
Overall lower system cost than LVDTs or other digital gaging probes.
-
Self contained electronics to provide a digital output, suitable for interfacing to a PC.
-
Reduces clutter and expense by eliminating innumerable system components.
-
Used for gaging and positioning measurement.
-
An LVDT or half bridge, with better performance.
-
Pre-calibrated at the factory.
-
No recurrent re-calibration.
-
Minimal setup time. Plug and play.
-
Requires single master only, so halves the cost of needing MIN and MAX masters.
-
Quantity usage limited only by number of available USB ports on PC or hubs.
-
Low cost basic gaging software.
-
Optional interface to SPC programs.
